Carboline Carbomastic® 615 AL 5 gal

Manufacturer: Carboline
Product Description

Carboline® Carbomastic®615 AL is a high performance, aluminum-filled epoxy with excellent resistance to fresh and salt water exposures.

This coating exhibits outstanding moisture and surface tolerance during application, low temperature cure capability, and very fast cure response for quick return to service. The aluminum-pigmented epoxy enhances film strength and performance because of the inert flake reinforcement (micaceous iron oxide).

$0.00
  • Unique formulation with aluminum flakes provides exceptional barrier protection
  • High solids, low VOC
  • Low temperature cure
  • Excellent wetting properties
  • Excellent surface tolerance
  • Excellent moisture tolerance during application
  • Fast cure response
  • Suitable for immersion service in fresh or salt water after 60 minute cure @75°F

Listed below are general equipment guidelines for the application of this product. Job site conditions may require modifications to these guidelines to achieve the desired results.

General Listed below are the general equipment guidelines for the application of this product. Job site conditions may require modifications to these guidelines to achieve the desired results.

Spray Application (General) Hold gun 12-14 inches from the surface and at a right angle to the surface. Conventional Spray Pressure pot equipped with dual regulators, 3/8” I.D. minimum material hose, 0.070” I.D. fluid tip and appropriate air cap.

Airless Spray
Pump Ratio: 30:1 (min.)
Volume Output: 9.5 l/min min. (2.5gpm min.)
Material Hose: 9.5mm min. (3/8” I.D. min.)
Tip Size: 0.43-0.53mm (0.017-0.021”)
Output Pressure: 140-175kg/cm² (2000-2500 psi) Use a 1/2” minimum I.D. material hose
*PTFE packings are recommended and available from pump manufacturer.

Brush & Roller (General) Not recommended for tank lining applications except when striping welds. For non-immersion applications over damp surfaces, brush and roller is the preferred method. Multiple coats may be required to obtain desired appearance, recommended dry film thickness and adequate hiding. Avoid excessive re-brushing or re-rolling. For best results, tie-in within 10 minutes at 75°F (24°C). Thin up to 11% by volume per gallon with Carboline Thinner #2. Use a short-nap synthetic roller cover with solvent resistant core.